Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 203)

Report Generation
Chapter 17
17-9
The 1770-T3 industrial terminal screen size is 80 columns across by 24
lines down. An example message using graphic and alphanumeric
characters is shown in Figure 17.5.
Figure 17.5
Example Graphic/ Alphanumeric Message
Liquid
Heater
Coil
Outlet
Inlet
Temperature
Sensor
Steam Return
Steam Inlet
Tank
PV
SP
10261ĆI
The control code, [CTRL][P]<Column #>[;]<Line #<[A], should be used
for cursor positioning to conserve memory when possible. For example,
[CTRL][P][3][9][;][9][A] uses 3 words of memory, storing CRTL P in one
byte and remaining characters in one byte each. If the cursor had been at
column 0, and line 0, normal space, and line feed commands were used, it
would have taken 24 words of memory to accomplish the same thing.
Note that the column and line numbers begin at zero rather than one.
The report generation function is entered by pressing
[RECORD][DISPLAY] on the standard 1770-KCB alphanumeric keytop
overlay. There are six report generation commands used to enter control
words and to store, print, report and delete messages and to display an
index of existing messages. Table 17.E summarizes these commands.
Report Generation Commands