Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 33)

Hardware
Chapter 3
3-7
Installation
Before you start to program your processor make sure all of your
peripheral equipment is installed properly. Follow these basic instructions
to install the industrial terminal to the processor. Refer to Figure 3.4 when
following these instructions.
Figure 3.4
Industrial Terminal Installation
Channel A
Industrial Terminal
(rear view)
Program Panel
Interconnect Cable
Interface
MiniĆPLCĆ2/05
PLCĆ2 Family
10249
1. Plug the ac power cord of the industrial terminal to the incoming
ac power source.
2. Connect one end of the PLC-2 Program Panel Interconnect Cable
(cat. no. 1772-TC) to CHANNEL A at the rear of the
industrial terminal.
3. Connect the other end of the cable to the socket labeled INTFC at the
front of the processor.