Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 186)

Program Editing
Chapter 16
16-9
First Condition or Output Instruction in a Rung
Keystrokes: When the processor is operating in the remote program
mode, you can access the first condition instruction of a rung from
anywhere in the rung by performing the following steps.
1. Press [SEARCH][
←
].
When the processor is not in the program mode, the cursor moves off the
screen to the left. To bring it back on the screen:
2. Press [
→
].
Keystrokes: When the processor is operating in any mode, you can access
the output instruction by performing the following step.
1. Press [SEARCH][
→
].
Single Rung Display
Upon power-up, a multiple rung display appears on the screen.
Keystrokes: You can select the single rung format by performing the
following steps.
1. Press [SEARCH][DISPLAY].
You can return to the multiple rung display.
2. Press [SEARCH][DISPLAY] again.
Incomplete Rung
You can locate an incomplete rung caused by an interruption in
programming in any processor operating mode.
Keystrokes: You can locate the incomplete rung by performing the
following steps.
1. Press [SHIFT][SEARCH].
First and Last Rung and User Program Bounds
You can locate the program boundaries including the first or last rung from
any point in the program.
Keystrokes: You can locate these boundaries by completing the
following steps.
1. Press [SEARCH][
↑
] or [SEARCH][
↓
].
The user program could contain a temporary end instruction boundary
and/or a subroutine area boundary. It always contains an END
statement boundary.