Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 207)

Report Generation
Chapter 17
17-13
Message PrintĆMP
Accessible in any mode, the message print command is used to print the
contents of a message to verify it. This command is accessed by pressing
[M][P][,]<message number>[RETURN]. Valid message numbers are
listed under MESSAGE STORE.
In the example, the message print command would give the following
MP,
[RETURN]
The screen does not change.
SR6 IS *01305* IN CYCLE #030#
The message print command is self-terminating. You can press [ESC] or
[CANCEL COMMAND] to return to ladder diagram display.
Message ReportĆ MR
Accessible in ay mode, the message report command prints a message with
the current data table value or bit status that corresponds to an address
between the delimiters. This command is accessed by pressing
[M][R][,]<message number>[RETURN].
In the example, the message report command gives the following: (e.g. bit
013/05 is on and counter 030 accumulated value is 5)
MP,
[RETURN]
The screen does not change.
SR6 IS ON IN CYCLE 005
The message report command is self-terminating. When you press [ESC]
or [CANCEL COMMAND], ladder diagram operation resumes.