Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 56)

Relay-type Instructions
Chapter 6
6Ć4
Keystrokes: Enter an Examine On or Examine Off instruction by performing
the following steps.
1. Press either -] [- or -]/[- as required.
2. Enter <address>.
Removing the Examine On or Examine Off Instruction
You remove an Examine On or a Examine Off instruction by performing the
following steps.
1. Position the cursor over the Examine On or Examine Off instruction you
want to remove.
2. Press [REMOVE] -] [- or -]/[-.
Editing a Partially Completed or a Completed Rung
You edit an Examine On or Examine Off by performing the following steps.
If you are editing a completed rung, proceed to step 1. If you are editing a
partially completed rung, enter the next instruction and proceed to step 1.
1. Position the cursor over the Examine On or Examine Off instruction you
want to edit.
2. Press either -] [- or -]/[- or any other appropriate instruction type key.
3. Enter <address>.
Bit Controlling
Output Energize
Purpose: This Output Energize instruction tells the processor to set or reset a
specified data table bit.
112
06
012
15
Bit Controlling
Output Energize
Controls a specific bit based on the rung condition. When its rung
conditions are:
True - Output Energize sets a specified bit.
False - Output Energize resets a specified bit.