Rockwell Automation 2711 PanelBuilder Software Getting Started - Manual (Page 22)

Chapter
2
Publication 2711-6.2
Initial System Setup
This chapter contains these sections.
Sections Page
Setting up System Components 2–1
Loading the SLC Ladder Logic Program 2–5
Loading the PLC Ladder Logic Program 2–5
This section shows how to set up the system components that are
required to install, download and run the sample application.
System Components for PanelView with DH-485 Ports
•
DH-485 PanelView Terminal
•
Personal Computer with installed:
– PanelBuilder Software
– Advanced Programming Software (APS)
•
SLC 500 Controller
•
2 Communication Cables (Catalog No. 1747-C10, -C11 or -C20)
•
Personal Computer Interface Converter (Catalog No. 1747-PIC)
Make the connections shown below. No other connections are
required.
Node 0
Personal Computer
Personal Computer
Interface Converter
Catalog No. 1747-PIC
Node 1
SLC Controller
PanelBuilder
Node 2
PanelView 900 DH-485 Terminal Shown
Cable
Catalog No. 1747-C10, -C11, -C20
Serial Port
COM1 or COM2
DH-485 Connector DH-485 Connector
Chapter Objectives
Setting up
System Components