Rockwell Automation 2711 PanelBuilder Software Getting Started - Manual (Page 97)

8–4 Running the Application
Publication 2711-6.2
4. Enter a value of 500 in the scratchpad and press
Objects are automatically updated to reflect the new speed.
500
500
5. Press
F1
key to increase the motor speed.
Or if the terminal has a touch screen, press MENU
F5
Objects are updated to reflect the new speed.
6. Press
F1
key twice to increase the speed again.
Or hold down F1 until the speed increases by 20 RPM.
7. Hold down the
F2
key until the speed decreases 30 RPM.
Or if the terminal has a touch screen, press
MENU
F5
Objects are automatically updated to reflect the new speed.
The following alarm messages are triggered in manual mode.
•
MOTOR SPEED TOO HIGH when motor speed is greater than
950 RPM.
•
MOTOR SPEED TOO LOW when motor speed is less than 50
RPM
"