Rockwell Automation 2711 PanelBuilder Software Getting Started - Manual (Page 94)

Chapter
8
Publication 2711-6.2
Running the Application
This chapter shows how to run the application in the PanelView 900
terminal. It contains these sections.
Sections Page
Running the Motor in Auto Mode 8–1
Running the Motor in Manual Mode 8–3
This section shows how to monitor the motor in auto mode. In auto
mode, the motor is controlled by the SLC or PLC and continually
changes speed. All keys that are pressed in the procedure that
follows are located on the PanelView terminal.
After the application is downloaded, the PanelView terminal displays
the Motor Status screen.
The Motor Status indicators show that the motor is started and in
Auto mode.
To monitor the status of the motor in auto mode:
1. Press the
F2
key to stop the motor.
Or if the terminal has a touch screen, press
Notice how the Start and Stop motor push buttons change
appearance to show the change in state.
The Status indicator in the Motor Status box also shows the
current status of the motor.
Chapter Objectives
Running the Motor
in Auto Mode