Rockwell Automation 2711 PanelBuilder Software Getting Started - Manual (Page 82)

5–5 PanelView Terminal Setup
Publication 2711-6.2
This section shows how to define runtime communication
parameters for DH+ version of the PanelView terminal.
To configure DH+ communications:
1. Choose Terminal Setup from the Application menu.
2. Select the Setup tab.
The dialog shows the name and type of PanelView 900 terminal
defined for the application. The dialog would look similar for
any PanelView terminal.
The terminal name was defined when the application was created.
3. Click from the Setup tab.
The DH+ Communication Setup dialog opens for the terminal.
4. Set parameters to match those shown in the dialog below.
DH+ Communications Dialog
Terminal Name
from Setup tab
Select 19200
Select 1
Select 2
Select 57600
Type SLC_1 SLC_1
Note: SLC_1 is entered to match
the node name in the GS project
(tag database).
5. Click the Apply button.
6. Click OK to return to the Terminal Setup dialog.
7. Click OK to close the Terminal Setup dialog.
DH+ Communication
Settings
"