Rockwell Automation 2711 PanelBuilder Software Getting Started - Manual (Page 79)

5–2 PanelView Terminal Setup
Publication 2711-6.2
This section shows how to define runtime communication
parameters for a Remote I/O version of the PanelView terminal.
Skip to page 5–4 if defining runtime communication parameters for
a DH-485 or RS-232 terminal. Skip to page 5–5 if defining runtime
communication parameters for a DH+ terminal.
To configure Remote I/O communications:
1. Choose Terminal Setup from the Application menu.
2. Select the Setup tab.
The dialog shows the name and type of PanelView 900 terminal
defined for the application. The dialog would look similar for a
PanelView 550 terminal.
The terminal name was defined when the application was created.
3. Click from the Setup tab.
The Remote I/O Communication Setup dialog opens.
4. Set parameters to match those shown in the dialog below.
Remote I/O Communications dialog
Terminal Name
from Setup tab
Select PLC 5/25
Select 1
Select all check boxes
Select 57600
Defining Remote I/O
Communication Settings
"