Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 12)

3-4 Transportation and Handling
7712-IN001B-EN-P – June 2013
Fork Lift Truck
A single fork lift truck may be used, extreme caution must be exercised.
1. Insert the forks into openings of the shipping skid from the rear of the
controller.
2. Carefully balance the controller on the forks and apply safety straps.
Shipping Skid Removal
Internal access is required to remove the wooden shipping skid from the
Motor Control Center cabinets. External angle brackets attached to the
enclosure are used to attach the enclosure to the wooden skid.
Remove the angle brackets and the associated hardware.
When the enclosure is lifted by overhead means the wooden skid can be
removed.