Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 30)

4-18 Equipment Installation
7712-IN001B-EN-P – June 2013
4.7 Floor Anchoring
Take out front and back lag bolts. Then drill through these holes into the
fl at and level concrete fl oor. The anchor holes accommodate 12 mm (.50”)
hardware. Secure to 75 ft-lb/102 N·m.
Figure 4.27 – Front of Cabinet Anchor Bolt Location
Figure 4.28 – Back of Cabinet Anchor Bolt Location
ATTENTION The cabinet must be securely attached to the fl oor or
there is a risk that the starter could fall over.
Remove bolts from
front anchoring
bolt holes
Remove bolts from
back anchoring
bolt holes