Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 9)

Transportation and Handling
Overview
The controller sections are shipped on wooden skids bolted to the cabinetry.
Lifting angles are installed at the top of the cabinetry. The controller sections
must be maintained in the upright position during any handling.
Ensure that the load rating of all lifting equipment is
suffi cient to safely raise the controller sections. Refer to
the packing slip for shipping weights.
Round rollers can be used to assist in moving the equipment to the installation
site. Once at the fi nal site, rollers can be used to place the sections in their
desired position.
Care must be exercised when using either a forklift or the
pipe rolling technique for positioning purposes to ensure
that the equipment is not scratched, dented or damaged
in any manner. Always exercise care to stabilize the
controller during handling to guard against tipping and
injury to personnel.
It cannot be stressed how important it is that the customer
installation duties are performed correctly. Any errors
will likely cause delays in commissioning or damage to
the equipment.
Chapter
3
7712-IN001B-EN-P – June 2013
I M P O R T A N T I M P O R T A N T