Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 3)

Table of Contents
7712-IN001B-EN-P – June 2013
Chapter 1 Equipment Overview
Overview ................................................................................. 1-1
Chapter 2
Overview .................................................................................. 2-1
Chapter 3
Overview ................................................................................ 3-1
Cabinet Handling Instructions ................................................ 3-2
Overhead Lifting Method ................................................. 3-2
Rod and Pipe Rollers ........................................................ 3-3
Fork Lift Truck ................................................................. 3-4
Shipping Skid Removal .................................................... 3-4
Chapter 4 Equipment Installation
4.1 Removal of Overhead Lifting Brackets .................... 4-1
4.2 Open MV Door .......................................................... 4-2
4.3 Removal of the Contactor Cart .................................. 4-3
4.4 Remove Inter Compartment Barrier .......................... 4-7
4.5 Remove Bottom Conduit Cover ................................ 4-9
4.6 Final Product Placement and Joining of Adjacent Units . 4-9
4.6.1 Mechanical Connections between Enclosures . 4-11
4.6.1.1 Joining Incoming Breaker to Starter ........... 4-15
4.6.1.2 Joining Incoming Section to Starter ........... 4-16
4.6.1.3 Joining Section to Section .......................... 4-17
4.7 Floor Anchoring ...................................................... 4-18
4.8 Connecting to Load Terminals ................................ 4-19
4.9 Ground Bus Linking ................................................ 4-20
4.10 Main Bus Linking .................................................... 4-21
4.11 Placing the Contactor Back Into the Starter ............. 4-25
Chapter 5
Procedure ................................................................................ 5-1
Appendix A Torque Values
Torque Values for Hardware .................................................. A-1
Unpacking and
Inspecting
Transportation
and Handling
Standard Plenum
Assembly Procedure