Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 5)

Equipment Overview
Overview
The OneGear™ Bulletin 7712 controller is a one-high full voltage non-
reversing starter. The starter comes with the following standard items:
• Drawout Vacuum Contactor
• Main Power Rated Fuses
• Low Voltage Control Panel with low voltage controls
Figure 1.1 shows an overview of a typical Motor Control Center complete
with two Bulletin 7712 units and a Bulletin 7791 incoming line unit.
Refer to project documentation for specifi c confi guration details and
dimensions.
Incoming Cabinet
(Bulletin 7791)
Starter Cabinet
(Bulletin 7712) Starter Cabinet
(Bulletin 7712)
Note:
This dimension includes the end side sheet of metal.
531,5
[20.92] 350,0
[13.78] 381,5
[15.02]
Figure 1.1 – Typical Bulletin 7712 OneGear™ One-High Starter
All cabinets are shipped individually or as part of a shipping split. This
document describes the handling and installation of the starter and with
Incoming Breaker, Incoming Section and Joining Section-to-Sections.
Installation and connection instructions for switchgear cabinets, that are
adjacent to each other is covered by the respective manufacturer’s
documentation and is not included in the scope of this document.
Chapter
1
7712-IN001B-EN-P – June 2013