1 joining incoming breaker to starter – Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) User Manual
Page 27
Advertising
Equipment Installation
4-15
7712-IN001B-EN-P – June 2013
4.6.1.1 Joining Incoming Breaker to Starter
Place the breaker and starter beside each in their fi nal position.
Ensure that the two units are in the correct position such that the joining
holes in one cabinet match the opposite bolt hole connections.
Figure 4.23 – Joining Incoming Breaker to Starter
Figure 4.24 – Aligning Incoming Breaker to Starter
Incoming Breaker
(2) Front Junction Points
inside LV panel
(2) Front Junction Points
inside MV panel
Starter Cabinet
(4) Rear Junction Points
Connecting bolts
to seal around
bus opening
Front flange faces
Advertising