Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 42)

5-4 OneGear™ Standard Plenum Assembly Procedure
7712-IN001B-EN-P – June 2013
Figure 5.5a – Attaching rear inner bracket and rear plate
9. Locate the top inner bracker (81021-959-51/52) for connecting to
switchgear temporarily using M8 hardware (see Figure 5.2b).
Figure 5.5b – Attaching top inner bracket
10. Take the front plate (81021-068-01/02) of 7712/7719 plenum assembly,
position it as shown in Figure 5.5c, and connect to OneGear top plate
using M8 hardware (M8 HHCS, 28 mm [1.25"] OD fl at washers and
lock washer).