Rockwell Automation 7712 OneGear Motor Control Center FVNR Starter (7.2 kV) - Manual (Page 7)

Unpacking and Inspecting
Overview
Before leaving the factory, the controller has been tested mechanically and
electrically.
Immediately upon receiving the controller, remove the packing and check
for possible shipping damage. Report any damage immediately to the
claims offi ce of the carrier.
After unpacking, check the items received against the Bill of Lading to
ensure that the nameplate description of each item agrees with the material
ordered. Inspect the controller for physical damage as stated in the Rockwell
Automation Conditions of Sale.
All claims for breakage and damage, whether concealed
or obvious, must be made to the carrier by the customer
as soon as possible after receipt of the shipment. Rockwell
Automation will render reasonable assistance in the
securing of adjustment for such damage claims.
Remove all packing material, wedges or braces from within the controller.
If any part of the equipment will not be installed when it is unpacked, it
should be stored in a clean dry place. The storage temperature must be be-
tween -20 °C (-4 °F) and 75 °C (167 °F) with a maximum humidity of 95%
non-condensing.
Chapter
2
7712-IN001B-EN-P – June 2013
I M P O R T A N T I M P O R T A N T