Rockwell Automation 5370-CBPK Color CVIM BLISTER-PAK Option - Manual (Page 16)

Chapter
3
Chapter 3
Installing the BLISTER–PAK Option
Figure 3Table 3
3–1
Installing the BLISTER-PAK Option
This chapter contains information that will help assure a smooth and
successful installation of the BLISTER-PAK option on your Color CVIM
module. It includes the following information:
•
Installing the Color CVIM BLISTER-PAK option.
•
Using the Color CVIM BLISTER-PAK option with the MATH-PAK and
USER-PAK options.
The Color CVIM BLISTER-PAK option is provided on a single memory
card. You need install the BLISTER-PAK option only once. The
BLISTER-PAK option remains installed for all subsequent powerup cycles.
Important: Installation of the Color CVIM BLISTER-PAK option results in
modification of the standard Color CVIM firmware, and is not
reversible.
!
ATTENTION: Inspection configurations created under the
standard Color CVIM firmware cannot be used with the
BLISTER–PAK software, and vice versa. Any configurations
created and stored using standard Color CVIM firmware
will be rejected by the BLISTER–PAK software.
Use the following steps to install the BLISTER-PAK option on your Color
CVIM module:
1. Remove power from the Color CVIM module.
2. Insert the BLISTER-PAK option card in the Archive Memory slot on the
front of the Color CVIM module. Insert the end with the metal strip
facing right as shown in Figure 3.1 on page 3–2.
Installation