Rockwell Automation 5370-CBPK Color CVIM BLISTER-PAK Option - Manual (Page 74)

Chapter 9
Reject Tracking
9–4
Table 9.B
Discrete Bit Inputs (Excerpt From Table B.1, Part 3)
*PI Backplane Remote I/O *RS–232 ASCII *RS–232 DFI
Word # Bit #
Definition Usage Notes
0 0
Machine Stop
Condition
0 = No
Condition
1 = Condition
This bit indicates whether or not a
Machine Stop has occurred.
0 1 Configuration Error
0 = No Error
1 = Error
Configuration error bit is set after
any invalid configuration block write
to the Color CVIM. This flag is also
set after validation errors.
0 2 Mastership Flag
0 = Not Master
1 = Master
The device which reads this bit as 1
is the host. Not applicable for
RS–232 communications.
0 3 Module Busy
0 = Not Busy
1 = Busy
Module Busy bit is set during the
SETUP mode and while sending a
configuration download to the Color
CVIM.
0 4
Trigger
NAK
0 = OK
1 = Trigger
Missed
0 5 Post Results
0 = Part 1
1 = Part 2
0 6
Toolset
Data Valid
0 = Not Valid
1 = Results
Valid
Data Valid bit is reset when a user
enters the SETUP mode and when
pulsed output duration has expired.
Refer to Chapter 3.
0 7 Post Tracking
0 = No Tracking
1 = Tracking This bit indicates whether or not
tracking data is present.
0 10–16 Machine Type
Value from 0 to
127 (decimal)
This is a 7–bit value.
0 17 Web Movement
0 = Horizontal
1 = Vertical
This is a 1–bit value.
1 0–7 Inspection Steps
Value from 0 to
255 (decimal)
This is an 8–bit value.
1 10–17 Bad–seal Steps
Value from 0 to
255 (decimal)
This is an 8–bit value.
2 0–7 Web–splice Steps
Value from 0 to
255 (decimal)
This is an 8–bit value.
2 10–17 Seal–splice Steps
Value from 0 to
255 (decimal)
This is an 8–bit value.
3 0–3
**Steps per field of
view
Value from 0 to
15 (decimal)
This is a 4–bit value.
3 4–7
**Lanes per field of
view
Value from 0 to
15 (decimal)
This is a 4–bit value.
3 10–17 Not used 0 All bits = 0.
4–7 All Not used 0 All bits = 0.
*The reject tracking parameters are available only through the Remote I/O port.
**These values reflect the Web Movement parameter setting.