Rockwell Automation 5370-CBPK Color CVIM BLISTER-PAK Option - Manual (Page 21)

Chapter
5
Chapter 5
Auto Setup
Figure 5Table 5
5–1
Auto Setup
The Color CVIM BLISTER-PAK
t option provides a number of
enhancements to the Color CVIM module that help make it easy to set up
and use blister packaging inspection applications. The auto setup feature is a
key element in that flexibility and improved usability.
Auto setup simplifies the job of defining the large number of inspection tools
commonly required for blister packaging inspection applications. Auto setup
allows almost anyone to learn quickly how to configure and use the Color
CVIM for blister inspection.
Use this chapter as a guide as you create an inspection configuration that
meets particular needs presented by a particular blister. It includes
information on using the auto setup feature.
When you select the Setup menu item from the run mode, the module will
enter either the system setup mode or the blister setup mode. To access the
blister setup mode while in the system setup mode, click on the
Exit menu
item.
Before beginning the auto setup process for the first time, you should set the
following parameters in the
Configure menu as required for your blister
inspection application:
•
Teach count.
•
Minimum position tolerance.
•
Minimum area tolerance.
•
Minimum shape tolerance.
•
Variation scale.
The Color CVIM BLISTER-PAK software provides default settings for each
of these parameters, but you can modify them as required. You can change
the default configuration values to meet your specific needs at any time
before auto setup. To do so, select the
Configure menu item in the Blister
Setup menu bar, then select the specific parameter item from the Configure
menu. Use the onscreen calculator (Figure 5.1 on page 5–2) to enter a new
value.
Accessing Blister Setup
Configuring Auto Setup