Rockwell Automation 5370-CBPK Color CVIM BLISTER-PAK Option - Manual (Page 71)

Chapter
9
Chapter 9
Reject Tracking
Figure 9Table 9
9–1
Reject Tracking
This chapter contains information about the reject tracking feature, which
enables you to configure a specific set of reject tracking parameters for later
uploading to your PLC
t or SLCt.
When you pick the Tracking menu item in the Blister Setup menu bar, the
Tracking menu appears, as shown in Figure 9.1.
Figure 9.1
Tracking Menu
You can configure each menu item in the Tracking menu by selecting a
value that is appropriate for your application, subject to the following limits:
•
Machine Type –– Select a value between 0 and 127.
•
Web Movement –– Select Vertical or Horizontal (should match the
direction that the web moves in the image field).
•
Inspection Steps –– Select a value between 0 and 255.
•
Bad–seal Steps –– Select a value between 0 and 255.
•
Web–splice Steps –– Select a value between 0 and 255.
•
Seal–splice Steps –– Select a value between 0 and 255.
NOTE 1: The reject tracking parameters have no effect on the operation of
your blister inspection application; instead, they serve mainly as a convenient
method of re–configuring the PLC remotely when you change your blister
inspection application at the color CVIM monitor. The usage of these
parameters is determined solely by the PLC program.
NOTE 2: The text appearing in each menu item of the Tracking menu is the
factory installed default version. However, by using the Change Text
feature of the Color CVIM USER–PAK
t Option, you can change the text, if
appropriate, to correspond to the nomenclature used in your reject tracking
operations. Refer to Appendix A for details.
Tracking Menu