Rockwell Automation 5370-CBPK Color CVIM BLISTER-PAK Option - Manual (Page 43)

Chapter
Chapter 6
Adjusting Blister Windows
6
Figure 6Table 6
6–1
Adjusting Blister Windows
This chapter contains information about the Adjust menu, which you can use
to “fine tune” the blister window configurations produced by the auto setup
process (auto setup is described in Chapter 5).
Briefly, the Adjust menu provides these adjustment functions:
•
Applies adjustments to one blister window, or to all windows
simultaneously.
•
Changes the size or position of a window.
•
Adjusts tolerances.
•
Defines background inspection.
•
Changes the shape of a window; configures binary morphology.
When you click on the Adjust item in the Blister Setup menu, the Adjust
menu appears, as shown in Figure 6.1.
Figure 6.1
Selecting Adjust Menu
Sometimes you will want to modify all the windows on screen
simultaneously. For example, you may change the design of your packaging,
and therefore need to change the size of all the active windows in your
inspection. At other times, you may want to adjust one or more windows
without affecting the others on screen. The
Adjust All / Adjust One menu
item in the Adjust menu gives you the choice.
When you pick this menu item, it toggles to the alternate state. Thus, if it
currently displays
Adjust All , it toggles to Adjust One (and vice versa).
When the setting is Adjust All , every window appears outlined in red. Any
change you make to the position or parameters of one window will apply to
all windows.
When the setting is Adjust One , any changes you make to the position or
parameters of one window will apply only to that window. The currently
selected window appears outlined in red, while all other windows appear
outlined in green. When
Adjust One is in effect, you can click on any
window to make it the “current” window.
Adjust One or All