Rockwell Automation VSM500 Integrated Drive/Motor - Manual (Page 2)

©2000 Rockwell International Corporation
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety considerations:
Important: Identifies information that is critical for successful application and understanding of the product.
The thick black bar shown on the outside margin of this page will be used throughout this instruction manual to
signify new or revised text or figures.
!
ATTENTION: Identifies information about practices or circumstances that can lead to personal
injury or death, property damage, or economic loss.
DeviceNet™ is a trademark of the Open DeviceNet Vendor Association.
VSM500™ and Reliance™ are trademarks of Rockwell Automation.
!
ATTENTION: Only qualified personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, and/or service this equipment.
Read and understand this instruction manual in its entirety before proceeding. Failure to observe
this precaution could result in severe bodily injury or loss of life.
ATTENTION: After disconnecting input power, wait five minutes and check with a voltmeter to
insure that DC bus capacitors are discharged. The voltmeter should read zero volts. Failure to
observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: High voltage and rotating parts can cause serious or fatal injury. Installation,
operation, and maintenance of electrical machinery should be performed by qualified personnel.
Make sure that the motor and equipment are grounded and protected in accordance with the
National Electric and local codes. See NEMA MG-2 safety standard.
ATTENTION: The user is responsible for conforming with all applicable local, national, and
international codes. Failure to observe this precaution could result in personal injury and/or
damage to, or destruction of, the equipment.
Trademarks not belonging to Rockwell Automation are property of their
respective companies.