Rockwell Automation VSM500 Integrated Drive/Motor - Manual (Page 35)

Step 7 - Wire the Control Signal Terminal Block 7-5
7.2 Wiring the Analog Output
The analog output provides a 0 to 10 VDC signal to a user-supplied metering device.
This output indicates speed (default) or %load (user option), based on the status of
input terminal 12.
If you select speed indication, 0 to 10 V = 0 to the maximum speed as defined by the
maximum speed rotary switch. (Refer to chapter 8 for a description of the rotary
switch.)
If you select %load indication, 0 to 10 V = 0 to 200% load.
Wire to the analog output as shown in figure 7.5.
Figure 7.5 – Analog Output Wiring
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
Common
0 to 10V Output
20
_
+