Rockwell Automation VSM500 Integrated Drive/Motor - Manual (Page 5)

Contents III
List of Figures
Figure 1.1 – VSM500 Standard Unit......................................................................... 1-2
Figure 1.2 – VSM500 Local Operator Control Unit ................................................... 1-3
Figure 1.3 – Local Operator Controls Key Functions................................................ 1-4
Figure 2.1 – Component Location ............................................................................ 2-1
Figure 2.2 – Access Clearances............................................................................... 2-2
Figure 2.3 – Wire Routing Locations ........................................................................ 2-3
Figure 3.1 – NEMA Frame Mounting Dimensions .................................................... 3-2
Figure 5.1 – Removing the Cover............................................................................. 5-2
Figure 5.2 – AC Input Power Connections ............................................................... 5-2
Figure 7.1 – Control Signal Terminal Block .............................................................. 7-1
Figure 7.2 – Typical Control Signal Connections for Standard Units and
Local Operator Control Units Set Up for Terminal Block Control ......... 7-2
Figure 7.3 – Typical Control Signal Connections for Local Operator Control Units.. 7-3
Figure 7.4 – Function Loss Control Wiring ............................................................... 7-4
Figure 7.5 – Analog Output Wiring ........................................................................... 7-5
Figure 7.6 – Relay Control Output Wiring................................................................. 7-6
Figure 7.7 – RPM or %Load Display Wiring ............................................................. 7-7
Figure 7.8 – Preset Speed Input Wiring.................................................................... 7-8
Figure 7.9 – Speed Reference Potentiometer Wiring ............................................... 7-9
Figure 7.10 – 0 to 10 VDC External Speed Reference Wiring................................ 7-10
Figure 7.11 – 4 to 20 mA External Speed Reference Wiring.................................. 7-11
Figure 7.12 – Start / Stop Control Wiring................................................................ 7-12
Figure 7.13 – Forward / Reverse Control Wiring .................................................... 7-13
Figure 7.14 – Reset Control Wiring ........................................................................ 7-14
Figure 8.1 – Factory Settings for the Setup Rotary Switches and Slide Switch ....... 8-2
Figure 8.2 – Maximum Speed Rotary Switch ........................................................... 8-3
Figure 8.3 – Acceleration / Deceleration Rotary Switch ........................................... 8-4
Figure 8.4 – Setup Slide Switch Selections .............................................................. 8-5
Figure 8.5 – Torque Curves...................................................................................... 8-8
Figure 8.6 – Wiring Minimum Speed ...................................................................... 8-10
Figure 9.1 – Changing the Definition of Forward and Reverse................................. 9-2
Figure 9.2 – Rotating the Cover................................................................................ 9-3