Rockwell Automation VSM500 Integrated Drive/Motor - Manual (Page 27)

Step 5 - Wire AC Power to the Unit and Ground the Unit 5-3
5.1 Grounding the Unit
Connect the ground wire brought in with the incoming AC power to the unit’s
grounding screw (see figure 5.2). This grounding conductor must run unbroken from
the unit to earth ground. The recommended tightening torque is 2.6 Nm (32 in-lb).
!
ATTENTION: The user is responsible for conforming with all local,
national, and international codes applicable to the grounding of this
equipment. Failure to observe this precaution could result in severe
bodily injury or loss of life.