Rockwell Automation FactoryTalk View Machine Edition Users Guide - Manual (Page 251)

16-1
16
Transfer applications to a PanelView Plus
terminal
This chapter describes:
 Start FactoryTalk View ME Station.
 Set up communication drivers to use to transfer applications to a PanelView Plus 7,
PanelView Plus 6, PanelView Plus, or PanelView Plus CE terminal.
 Transfer applications and TrueType fonts to PanelView Plus 7, PanelView Plus 6,
PanelView Plus, or PanelView Plus CE terminals.
 Upload applications from a terminal to the development computer.
 Compare applications on the development computer with applications on the terminal.
For information about using your application at run time, see Chapter 17.
For information about using FactoryTalk View ME Station on the terminal, including
setting up communications, printers, and input devices, see the PanelView Plus Terminals
User Manual.
Summary of steps
Follow these steps to:
 Install hardware and software on a PanelView Plus 7, PanelView Plus 6, PanelView
Plus, or PanelView Plus CE terminal.
 Transfer your application to the PanelView Plus 7, PanelView Plus 6, PanelView Plus,
or PanelView Plus CE terminal.
For information about installing FactoryTalk View ME Station, see the FactoryTalk View
Machine Edition Installation Guide.
Install hardware and software on a PanelView Plus terminal
1. If you will be printing displays, alarms, reports, or diagnostics messages, connect a
printer to the USB or Network port.
PanelView Plus terminals support printing using the Microsoft Windows CE PCL3
printer driver, which is already installed on the terminal. Printing is supported for most
laser and ink-jet printers. If you have problems printing, check that your printer is
compatible with the PCL3 printer driver.