Rockwell Automation FactoryTalk View Machine Edition Users Guide - Manual (Page 576)

F ACTORY T ALK V IEW M ACHINE E DITION U SER ’ S G UIDE
A-8
• •
•
•
•
Unsupported graphic objects
These PanelBuilder 1400e objects are not supported in FactoryTalk View:
 Scrolling List (includes Cursor List, Multistate Indicator Object List, Local Message
Object List, Numeric Data Display Object List)
 Set Bit Cursor Point
Unsupported settings and controls
This section describes PanelBuilder 1400e settings and controls that are not used in
FactoryTalk View.
Controls for transferring run-time application files
PanelBuilder 1400e uses these optional controls for transferring files to the run-time
terminal:
 Transfer Inhibit control
 Transfer Request control
 Transfer Status control
These controls are not necessary in FactoryTalk View because the ME Transfer Utility
allows you to transfer the run-time project file while running a project on the run-time
terminal.
Settings and controls for alarms
FactoryTalk View does not use these PanelBuilder 1400e features and settings to manage
alarms:
 Alarm relays
 Bit alarm acknowledgement
 Remote Alarm Operation Hold Time. The PanelBuilder 1400e Remote Alarm Ack
Control Hold Time will be used for all alarm hold times. You can change the hold time
in the FactoryTalk View Alarm Setup editor, in the Advanced tab.
 Remote Alarm Control Delay Time. In FactoryTalk View, if an Ack connection is
assigned, when an alarm is acknowledged the Ack connection is set immediately,
without waiting for a delay time.
FactoryTalk View does not use these PanelBuilder 1400e controls to manage alarms:
 PLC Controlled Relay control
 PLC Controlled Audio control
 Acknowledge to PLC control (if the Alarm Acknowledge to PLC option is set to Bit)