Rockwell Automation FactoryTalk View Machine Edition Users Guide - Manual (Page 40)

F ACTORY T ALK V IEW M ACHINE E DITION U SER ’ S G UIDE
2-6
• •
•
•
•
To undock the Diagnostics List, drag the grab bars at the bottom left of the Diagnostics
List. If you can’t see the grab bars, drag the top edge of the Diagnostics List to make it a
bit larger.
To prevent the Diagnostics List from docking automatically while you move it across the
screen, hold down the Ctrl key on the keyboard while you move the Diagnostics List.
When the Diagnostics List is undocked, you can make it any size you want, for example
to view more than one message at a time. To resize the bar, drag an edge or corner until
the bar is the size you want.
To re-attach the Diagnostics List, double-click its title bar.
To clear the selected message in the Diagnostics List, click Clear. To clear all the
messages in the Diagnostics List, click Clear All.
Messages in the Diagnostics List
The types of messages that appear in the Diagnostics List depend on how you set up
FactoryTalk Diagnostics on the development system. For information about specifying
the types of messages to show, see page 10-3.
The status bar
The status bar shows information about the active window or about the selected tool or
menu item. The information that is shown depends on where the mouse pointer is. For
example, when you select a graphic object in the Graphics editor, the status bar shows
information about the selected object.
To detach the
Diagnostics List, drag
the grab bars.