Rockwell Automation FactoryTalk Alarms and Events Quick Start - Manual (Page 194)

FactoryTalk Alarms and Events System Configuration Guide
186
• •
• •
•
MSXML6
To check if you have MSXML6:
1. From the Start menu, select Control Panel, and then double-click Add or
Remove Programs.
2. Check to see if MSXML6 is included in the list. If it is not, install it.
To install MSXML6:
1. At the root of the FactoryTalk View SE or RSLinx Enterprise CD, open the Redist
folder, open the MSXML6 folder, and then double-click msxml6.msi.
2. Follow the on-screen instructions.
Windows Installer 3.1
To check if you have Windows Installer 3.1:
1. From the Start menu, select Control Panel, and then double-click Add or
Remove Programs.
2. Check to see if Windows Installer 3.1 is included in the list. If it is not, install it.
To install Windows Installer 3.1:
1. At the root of the FactoryTalk View SE or RSLinx Enterprise CD, open the Redist
folder, open the WindowsInstaller31 folder, and then double-click
WindowsInstaller--KB893803-v2-x86.exe.
2. Follow the on-screen instructions.
Step 3: Run the SQL Server Install batch file (not the .exe)
The batch file installs Microsoft SQL Server 2005 Express, Service Pack 2 on your
computer with the correct settings for logging alarms and events. The batch file will
configure the following settings for SQL Server:
„ Mixed-Mode authentication
Microsoft documentation recommends using the Windows Authentication Mode.
However, this requires a domain controller to provide centralized authentication
for remote database access. To allow remote access without a domain, Mixed
Mode must be used because it supports both Windows Authentication and SQL
Server Authentication. You’ll need to provide a password for the system
administration (sa) account.
„ allow remote connections to the database using the TCP/IP protocol
„ enable SQL Server Browser