Rockwell Automation FactoryTalk Alarms and Events Quick Start - Manual (Page 56)

FactoryTalk Alarms and Events System Configuration Guide
48
• •
• •
•
3. If you plan to use tag-based alarms, skip the rest of the steps in this section, and go
on to “Create a new shortcut to the controller” on page 49. If you are using built-in
alarm instructions in Logix5000 controllers, on the Alarms and Events tab, select
the Enable alarm and event support check box.
4. Clear the Enable history check box and then click OK. For information about
historical logging, see Chapter 9, “Set up historical alarm and event logging”.
The new server is added to the My Local Site application: