Rockwell Automation 2098 CompactLogix Indexing Motion Accelerator Toolkit Quick Start - Manual (Page 57)

Publication IASIMP-QS011B-EN-P — January 2009 57
Motion Logix Integration Chapter 5
7. Click Yes to the prompt
about inserting tags and
logic.
8. There may be a warning that tags were created, but close the DeviceNet Tag Generator tool
and return to your RSLogix 5000 project.
9. The program logic that was created can be found in the
Tasks folder of the project.
Do not make any changes to these programs or logic,
as your DeviceNet nodes may quit responding.
Link the New Tags to the DeviceNet Drives
These steps link the tags created by the tool to the axes programmed in the logic.
1. Double-click Controller Tags in the controller
Explorer window to open the tag editor.
2. At the bottom of the editor window that
opens, click the Edit Tags tab to enable
editing.