Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 108)

E-2 SP500 AC Drive Installation and Operation Manual Version 3.1
• be installed according to the instructions in this appendix.
Note that when using 15 – 20 HP SP500 drives, a special cover is required. The
model number of the SP500 cover kit is M/N 2CK4120. Follow the instructions
provided with the kit when replacing the cover. The instructions in this appendix
assume that the drive has the correct cover on it.
E.2 Installing the AC Mains Filter
This section describes how to identify and install the AC Mains Filters. These filters
have been designed to limit the conducted electromagnetic emissions to the AC power
mains from the SP500 drives.
Table E.1 identifies the SP500 drives that are in conformance with the standards listed
in section E.0 and their corresponding AC Mains Filters. Verify that you have the
correct AC Mains Filter for your application.
Use the following guidelines to mount the SP500 drive to the AC Mains Filter and then
mount the drive/filter assembly to a panel:
• Attach the SP500 drive to the AC Mains Filter. See figure E.1. No other type of
mounting is permitted. The required mounting hardware is supplied with the filter.
• Attach the SP500 drive/AC Mains Filter assembly to a panel or wall. See figure E.1
and table E.2 for mounting dimensions. The panel/wall surface does not have to be
conductive, although it is preferable. The user must supply the hardware for
mounting the drive/filter assembly to the panel/wall.
Table E.1 – AC Mains Filters
HP SP500 Model Number
AC Mains Filter
Model Number
1 1SU21001 2DF2282
1 1SU41001 2DF4283
2 1SU21002 2DF2282
2 1SU41002 2DF4283
3 1SU21003 2DF4283
3 1SU41003 2DF4283
5 1SU21005 2DF4283
5 1SU41005 2DF4283
7.5 1SU41007 2DF4284
10 1SU41010 2DF4284
15 1SU41015 2DF4285
20 1SU41020 2DF4285