Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 74)

8-2 SP500 AC Drive Installation and Operation Manual Version 3.1
To display or change additional parameters, repeat steps 3 through 6.
To exit program mode, press the MODE/ENTER key until a parameter number or
ERR is displayed; then press the STOP/RESET key.
Important: Parameter values and the keypad status (local or remote) are retained
through a line dip or power loss.
Step 4. Press the MODE/ENTER key to display the parameter value.
Step 5. Press the or key to change the value.
Note that if programming has been disabled
in parameter F-20 (Password Lockout
Enable), the value will not change. Refer to
section 8.2, Ensuring Program Security, for
more information.
Step 6. Press the MODE/ENTER key to save the changed value.
The parameter number is displayed again.
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse