Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 121)

Index Index-3
Power-Up Start Enable (F-19), 8-13
Program mode, 7-4 to 7-5
R
Ratings
AC input, 2-7 to 2-8
NEMA, 2-7 to 2-8
power, 2-7 to 2-8
power loss, 2-7 to 2-8
Regulator board, 2-9 to 2-12, F-1 to F-2
Remote Reference Gain (F-11), 8-9 to 8-10
Remote Reference Offset (F-12), 8-10
Replacement parts, F-1 to F-2
Reset, digital input, 5-3, 5-7
Resistor, snubber braking, 2-13, 4-2 to 4-5,
5-8 to 5-9, A-2
Reverse, digital input, 5-3, 5-7
Reverse Disable (F-17), 8-12
Routing, wire, 4-1 to 4-5
RPM at Base Speed (F-08), 8-8
RPM Setpoint Enable (F-18), 8-13
S
Scaling the RPM display and reference, 7-6
Signal wiring, 5-3 to 5-10
Site requirements, 3-1
Snubber resistor braking, 2-13, 4-2 to 4-5, 5-8 to
5-9, A-2
Specifications
conduit opening sizes, 4-2 to 4-5
environmental, 3-1, A-1
dimensions, 3-2 to 3-3, A-1
drive inputs, A-2
drive outputs, A-2
service conditions, A-1
terminal torque ratings, 3-5
wire sizes, 3-4 to 3-5
Start, digital input, 5-5 to 5-7
Stop, digital input, 5-5 to 5-7
Stopping the drive, 3-9
T
Terminal strip
torque specifications, 3-5
wire sizes, 3-4 to 3-5
wiring, 5-3 to 5-10
Testing, IGBT, 9-7 to 9-10
Torque specifications, 3-5
Transformer, isolation, 4-6 to 4-7
V
Ventilation, see Air Flow
Version Information (F-49), 8-17
V/Hz (Base Speed) (F-07), 8-7 to 8-8
W
Watts loss rating, 2-7 to 2-8
Weights, A-1
Wire routing, 4-1 to 4-5