Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 111)

Compliance with Electromagnetic Compatibility Standards E-5
• When the drive is connected to three-phase AC input power, the three output leads
from the filter should be connected to the drive’s AC input power terminals as shown
in figure E.3.
• Connect the filter ground wire (green/yellow) to the drive ground.
.
Figure E.2 - Typical SP500 Single-Phase Connections
Figure E.3 - Typical SP500 Three-Phase Connections
R S T GND
U V W GND
SP500
L L L E(GND)
REDYELLOW BLUE YELLOW
AC MAINS FILTER
GREEN/
A B
1 2 3
MOTOR
FILTER’S AC INPUT POWER
DRIVE’S AC INPUT POWER
R S T GND
U V W GND
SP500
L L L E(GND)
REDYELLOW BLUE YELLOW
AC MAINS FILTER
GREEN/
A B
1 2 3
MOTOR
C
FILTER’S AC INPUT POWER
DRIVE’S AC INPUT POWER