Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 96)

9-6 SP500 AC Drive Installation and Operation Manual Version 3.1
Use the following procedure to access the error log:
:
Step 1. Enter program mode by pressing the MODE/ENTER key until the
PROGRAM LED turns on.
Step 2. Press the key until ERR is displayed. The error log precedes
parameter F-00 and follows F-49.
(Sample Display)
Step 3. Press the MODE/ENTER key to access the error log.
(Sample Display)
Step 4. Press the key to move through the error codes.
(Sample Display)
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse