Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 68)

7-4 SP500 AC Drive Installation and Operation Manual Version 3.1
7.4 Program Mode
Program mode allows you to display and modify drive parameter values when the
drive is stopped.
The following can be displayed in program mode:
• Parameter numbers
• Parameter values
• Error log information
To enter program mode:
Step 1. Stop the drive (if it is running) by pressing the STOP/RESET key.
Step 2. Press the MODE/ENTER key until the PROGRAM LED turns on.
Parameter F-00 will be displayed. Use the key or key to scroll through the
parameter list. The error log follows parameter F-49 and precedes parameter F-00 as
shown in figure 7.2.
To exit program mode:
Step 1. Press the MODE/ENTER key until a parameter number or ERR is displayed.
Step 2. Press the STOP/RESET key until the PROGRAM LED turns off.
Important: Pressing the STOP/RESET key while you are examining the error log
clears the log.
Figure 7.2 – SP500 Menu Structure
F-00
F-01
F-02
F-49
Err