Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 15)

Learning About the SP500 Drive 2-1
C
HAPTER
2
Learning About the SP500 Drive
This chapter describes the SP500 drive and how to identify it based on its model
number. This chapter also provides power and enclosure rating information.
2.1 Standard Features
The SP500 drive has the following features:
• On-board keypad and display providing:
Start/Stop/Reset control
Forward/Reverse (reverse-disable selectable)
Setpoint adjustment
Motor RPM, %load, or output voltage display
Drive diagnostics
• 500 millisecond power dip ride-through
• 150% overload for one minute (nominal)
• 0.5 to 240 Hz three-phase voltage output
• NEMA 1 and NEMA 4/12 enclosures
• A snubber resistor braking signal and a scaled voltage analog output
(0 to 10 VDC) which is proportional to:
Output frequency
Output amps
Output voltage
Selected reference
• Quiet motor operation with high carrier frequency selection
• Drive protection
Overcurrent
Short circuit
Ground fault
Overvoltage
Undervoltage
Overtemperature
• UL/CSA electronic overload that meets NEC/CEC requirements