Rockwell Automation SP500 AC Drive Installation and Operation Manual - Manual (Page 69)

Keypad and Display Operation 7-5
A sample program mode display is shown in figure 7.3.
7.5 Monitor Mode
Monitor mode is the keypad and display’s default mode of operation (in other words,
the keypad and display will return to monitor mode when you exit program mode). The
keypad and display must be in monitor mode before the drive can be put into run (RUN
LED is on) and will remain in monitor mode while the drive is running.
The following output data can be displayed in monitor mode:
• RPM
• %Load
• Volts
• Percent Selected Speed Reference (if F-13 = ON)
To select a value to monitor, press the MODE/ENTER key until the LED turns on next
to the desired display item. Pressing the MODE/ENTER key will advance you through
each of the displays. (Note that all the LEDs will turn on to indicate the percent
selected speed reference display if parameter F-13 is set to ON. Refer to section
7.5.2.)
Figure 7.3 – Example of a Program Mode Display
For information about: Refer to section:
Displaying or changing parameter values 8.1
Ensuring program security 8.2
Individual parameters 8.3
Accessing the error log 9.4
STOP
RESET
Mode
Enter
START
Forward
Reverse
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse