1 - prepare the distributed point i/o hardware, Before you begin, Chapter 1 – Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over a DeviceNet Network Quick Start User Manual
Page 13: Prepare the distributed point i/o hardware, Prepare the distributed, Point i/o hardware, Chapter
Advertising
Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012
13
Chapter
1
Prepare the Distributed POINT I/O Hardware
In this chapter, you learn how to complete the following tasks:
•
Install the 1734-ADN DeviceNet adapter
•
Install the 1734-OB4E digital output module
•
Install the 1794-PS3 FLEX I/O power supply
•
Connect power to the 1734-ADN DeviceNet adapter
Before You Begin
Before you begin, complete these tasks described in
Before Using This Publication on page 5
•
Prepare the Logix5000 control system hardware
- Verify the control system and DeviceNet
network are powered before using this chapter.
•
•
•
Create an RSLogix 5000 project
The example RSLogix 5000 project used in this quick start uses a CompactLogix 5370
L3 controller.
Advertising