Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over a DeviceNet Network Quick Start - Manual (Page 17)

Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012 17
Prepare the Distributed POINT I/O Hardware Chapter 1
Mount the 1734-OB4E Digital Output Module
1. Install the removable terminal base (RTB) on the mounting base; making sure the handle is
in the down position.
2. Using a small screwdriver, rotate
the keyswitch on the mounting
base to match the position on the
keyswitch on the 1734-OB4E
module.
This example shows the keyswitch
in position 1.
3. Press the 1734-OB4E module into
the wiring base.
4. Snap the handle up to lock the
RTB on the module.
5. Connect the wiring base assembly,
including mounting base, module,
and RTB, to the POINT I/O
Ethernet adapter via the slots on
the right side of the adapter.
6. Slide the wiring base assembly
along the right side of the network
adapter and press it onto the
DIN rail.
7. Slide the safety end cap onto the right side of the 1734-OB4E module.
Handle
Keyswitch
Mounting Base
Removable Terminal Block
Tongue-and-groove Slots
Module