Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over a DeviceNet Network Quick Start - Manual (Page 58)

58 Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012
Chapter 3 Use the POINT I/O Adapter and Output Module in an RSLogix 5000 Project
4. If not open, open the project’s Main Routine to find the ladder logic written earlier in this
chapter.
5. Select the PB and press Ctrl+T.
This toggles the state from 0 to 1
(off to on).
6. Verify that the light on the distributed digital output module turns on.
7. Press Ctrl+T to toggle the state
back to 0 (off ).
8. Go Offline.