Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over a DeviceNet Network Quick Start - Manual (Page 8)

8 Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012
Preface
Other Logix5000 Control System Quick Starts
This quick start describes how to use a single component-type over a single network in a
Logix5000 control system. Typically, though, a Logix5000 control system includes more than
the controller, communication module and a single component over a single network.
For example, if a Logix5000 control system operates on a DeviceNet network, the system might
use remote I/O modules, HMI devices and drives in addition to the controller and
communication modules.
For a complete list of Logix5000 control system quick starts that describe how to other devices in
Logix5000 control systems, see the Integrated Architecture:Logix 5000 Control Systems Quick
Starts Quick Reference, publication
IASIMP-QR024 .
The beginning of each chapter contains the following information. You should read these
sections before beginning work in each chapter:
• Before You Begin - This section lists the tasks you must complete before starting the
chapter.
• What You Need - This section lists the tools that are required to complete the tasks in the
current chapter. This includes, but is not limited to, hardware and software.
• Follow These Steps - This section illustrates the steps in the current chapter.