Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over a DeviceNet Network Quick Start - Manual (Page 21)

Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012 21
Chapter
2
Create DeviceNet Network Software Files
In this chapter, you complete the following tasks:
• Register an EDS file in RSNetWorx for DeviceNet software
• Set the DeviceNet scanner module’s node address
• Create a DeviceNet configuration file
• Change the POINT I/O DeviceNet network adapter’s configuration
• Change the DeviceNet network configuration
IMPORTANT
Multiple Logix5000 control systems can use POINT I/O modules over a DeviceNet network. For example purposes,
this quick start describes the use of POINT I/O modules over a DeviceNet network in a CompactLogix 5370 L3
control system.
If you have already completed the steps in this chapter before using this quick start, skip to Chapter 3 , Use the
POINT I/O Adapter and Output Module in an RSLogix 5000 Project on page 47 .