Rockwell Automation Logix5000 Control Systems: Connect POINT I/O Modules over a DeviceNet Network Quick Start - Manual (Page 14)

14 Rockwell Automation Publication IASIMP-QS026A-EN-P - July 2012
Chapter 1 Prepare the Distributed POINT I/O Hardware
What You Need
This table lists what products you need to complete the tasks described in this chapter.
Follow These Steps

Quantity Cat. No. Description
1 1734-ADN POINT I/O DeviceNet adapter
1 1734-OB4E POINT I/O protected output module
1 1734-TB POINT I/O mounting base assembly with base and removable terminal block
1 1734-RTB POINT I/O removable terminal block
1 POINT I/O end cap
1 1794-PS3
FLEX

FLEX I/O 85…264V AC to 24V DC 3 A power supply (1794-PS3)
1 1485K-P1F5-R5 KwikLink right-angle micro male to micro female connector cable
1 1485P-P1E4-R5 KwikLink sealed micro connector
1 1799-DNC5MMS 5-pin linear to micro male adapter
Mount and Connect
the 1734-ADN
DeviceNet Adapter
Mount the
1734-OB4E
Digital Output
Module
Mount and Wire the
1794-PS3 Power
Supply
Wire the 1734-ADN
DeviceNet Adapter
to the Power Supply
page 15
page 19
page 18
page 17
Adapter Status
System Power
DeviceNet Status
PointBus Status
Field Power
1734-ADN
24VDC Source Output
Module Status
Network Status
1734 OB4E
NODE:
0
1
2
3
Adapter Status
System Power
DeviceNet Status
PointBus
Status
Field Power
1734-ADN