Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 10)

1-2 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
Although most functions are the same, some functions are performed differently with
the OIM than they are with the front panel keypad/display. Some important differences
are:
• Pressing or on the OIM immediately starts the motor if the control
source is set to OIM. Make sure the motor and driven machinery are safe to start
before pressing either of these keys.
• For V/Hz regulation, the identification procedure (IDENTIFICATION RQST, H.020)
cannot be performed using the OIM. It must be performed through the front panel
keypad/display. You can review the results of the identification through the OIM by
viewing IDENTIFICATION RESULT (H.019).
• The control source is selected with a key ( ) in addition to a parameter
(P.000).
• The parameter names used in this instruction manual (I/M) are shown as they
appear on the OIM display. They are slightly different than the names that are used
in the GV3000/SE software I/M.
• SECOND MENU PASSWORD (P.006) only affects the GV3000/SE front panel
keypad/display and cannot be accessed through the OIM.
• Scaled speed units are set independently for the OIM and the front panel
keypad/display. This allows you to set different units for the two displays; for
example, RPM on the front panel keypad/display and inches per second (IPS) for
the OIM display. Front panel keypad/display units are set by FRONT PNL SPD
SCALING (P.028). OIM units are set by Define Speed Units in the Speed Control
menu.
1.2 Related Publications
This instruction manual (I/M) describes how to use the OIM with the GV3000/SE drive.
For information on drive hardware, such as drive installation and start up, see the
hardware I/M that corresponds to your system:
• D2-3360 GV3000/SE AC Power Modules Hardware Reference, Installation,
and Troubleshooting
• D2-3388 GV3000/SE AC Drive Hardware Reference, Installation, and
Troubleshooting 1-20 HP @ 230 VAC
• D2-3392 GV3000/SE AC Drive Hardware Reference, Installation, and
Troubleshooting 75-200 HP @ 460 VAC
• D2-3417 GV3000/SE AC Drive Hardware Reference, Installation, and
Troubleshooting 30-100 HP @ 230 VAC
• D2-3427 GV3000/SE AC Bookshelf Drive Hardware Reference, Installation,
and Troubleshooting