Hapter – Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide User Manual
Page 13
Advertising
Description of the OIM Keypad, Display, and Indicators
2-1
C
HAPTER
2
Description of the OIM Keypad,
Display, and Indicators
This chapter describes how to use the keypad, display, and indicators on the OIM to
program, monitor, and control the drive.
Figure 2.1 shows the OIM in program mode with keys, indicators, and screen
information called out.
2.1
The Keypad
The OIM keys are grouped by programming and control functions, as shown in
figure 2.1.
The control keys
,
, and
are only active if the control source is set
to OIM. Programming keys are always active.
Programming keys are described in table 2.1. Control keys are described in table 2.2.
Figure 2.1 – OIM Keypad, Display, and Indicators
Advertising