Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 73)

A-4 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
LEVEL SENSE START
EN* Level Sense Start
Enable Input P.054 Application Setup (V/Hz
and Vector)
LINE DIP RIDE THRU
TM Line Dip Ride-Through
Time Input P.042 Application Setup
(V/Hz)
LOSSES COMP GAIN* Losses Compensation
Gain Input U.028 Performance Tuning
(Vector)
⇒
Speed Loop
Tuning
LOW BUS FLT AVOID
EN* Low DC Bus Fault
Avoidance Enable Input U.023 Application Setup
(Vector)
⇒
Fault
Functions
MAGNET CURRENT
PRCNT Magnetizing Current Input U.006 Quick Start (Vector)
Motor Data (Vector)
MAN REF PRESET
ENABLE* Manual Reference
Preset Enable Input P.053 Application Setup
(V/Hz and Vector)
MAXIMUM SPEED Maximum Speed Input P.004 Speed Control
⇒
Speed
Limits
Quick Start
(V/Hz and Vector)
MINIMUM SPEED Minimum Speed Input P.003 Speed Control
⇒
Speed
Limits
Quick Start
(V/Hz and Vector)
MOP ACCEL DECEL
TIME MOP Accel/Decel Time Input P.023 Regulator Terminal Strip
⇒
MOP Configuration
MOP RESET CONFIG MOP Reset
Configuration Input P.024 Regulator Terminal Strip
⇒
MOP Configuration
MOTOR NAMEPL
AMPS Motor Nameplate Amps Input H.002 Motor Data (V/Hz)
Quick Start (V/Hz)
MOTOR NAMEPL
AMPS Motor Nameplate Amps Input U.004 Quick Start (Vector)
Motor Data (Vector)
MOTOR NAMEPL BASE
FRQ Motor Nameplate Base
Frequency Input H.001 Motor Data (V/Hz)
Quick Start (V/Hz)
MOTOR NAMEPL BASE
FRQ Motor Nameplate Base
Frequency Input U.003 Quick Start (Vector)
Motor Data (Vector)
MOTOR NAMEPL HP* Motor Nameplate
Horsepower Input U.022 Quick Start (Vector)
Motor Data (Vector)
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers (Continued)
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path